RCU Forums - View Single Post - Pull-pull setup
Thread: Pull-pull setup
View Single Post
Old 07-26-2004 | 01:11 PM
  #3  
JohnMcGowan
My Feedback: (15)
 
Joined: Dec 2001
Posts: 2,084
Received 2 Likes on 2 Posts
From: Birmingham, AL
Default RE: Pull-pull setup
Thanks Ken!! I am replacing the servos in the plane ( I didnt build it) as it only "had" Hitec standard servos installed on all the flying surfaces. I replaced them with 69 oz GWS servos.
I think my wires may be a little too tight cause I can just about play a tune on them LOL!!
Thanks again. John
JohnMcGowan is offline  
Reply Like