RCU Forums - View Single Post - Thread sizes
Thread: Thread sizes
View Single Post
Old 08-02-2004 | 05:54 AM
  #1  
ec-jjj
Junior Member
 
Joined: Dec 2002
Posts: 3
Likes: 0
Received 0 Likes on 0 Posts
From: Parla -Madrid, SPAIN
Default Thread sizes
Hello, my name is Jose,

I would like to know what is the thread diameter size in inches (so I can translate to mm.) of the 2-56 and 4-40 rods. Or if its possible where can I find a table with gauge numbers and its correspondence to diameter in inches.

Thank you, Jose
Club aeromodelismo Madrilenio
Madrid-Spain
ec-jjj is offline  
Reply Like