RCU Forums - View Single Post - Evolution .46 NT Engine
View Single Post
Old 08-09-2004 | 10:56 PM
  #9  
Dukester
Senior Member
My Feedback: (31)
 
Joined: Jul 2003
Posts: 846
Likes: 0
Received 0 Likes on 0 Posts
From: Houston, TX
Default RE: Evolution .46 NT Engine

You are going to like your Evo. Unfortunately, I totaled my Twist 40 this weekend with my Evo .46 on it. With a 12.25 x 3.75 APC 3D prop it would hover and full throttle would pull out again but not super fast pull out. Even though it ran fine right off, it did still get better with run time. In fact the last day of flying, I finally got it to the point where it had a stable idle and would go from idle to WOT without any kind of hiccup or hesitation. On a side note, I had to adjust the low speed needle factory range on mine about 1/4 turn to get it to run to my satisfaction.

I'm not sure what a Ucando weighs, but I would expect good performance from the Evo.

Duke