RCU Forums - View Single Post - Minimum Torque for R50 (later doin 3D stuff)??
Thread: Minimum Torque for R50 (later doin 3D stuff)??
View Single Post
Old 08-15-2004 | 01:52 PM
  #1  
iflynething
Senior Member
 
Joined: Aug 2003
Posts: 1,920
Likes: 0
Received 0 Likes on 0 Posts
From: Charlotte, NC
Default Minimum Torque for R50 (later doin 3D stuff)??
It's Michael again and I have another question. I'm gettin this R50 soon, and I have about 3 servos I'm considering with well over 90 oz/in but I'm just wondering what is the minimum torque that I would need for the R50 and still be able to DO 3D later when I get better??

I would call the Manuf. but I think they're in Thailand or China or something- I could call Ace Distributors but I'd just rather go on RCU and not have to spend anything on long distance!!

What ya think. I'm looking at the HS645's, HS625's and the Fut. 9202...I know they have enough torque and pretty good speed, but I'm just curious!!

Thanks Alot,

~Michael Carr~
iflynething is offline  
Reply Like