RCU Forums - View Single Post - How do I carve balsa?
Thread: How do I carve balsa?
View Single Post
Old 08-22-2004 | 05:23 PM
  #1  
Yub, yub, cmdr!'s Avatar
Yub, yub, cmdr!
Senior Member
 
Joined: Aug 2003
Posts: 2,592
Likes: 0
Received 0 Likes on 0 Posts
From: Worcester, MA
Default How do I carve balsa?
The instructions for my Citabria say that you have to carve two pieces of balsa for the leading edge blocks. I have no clue how to do this, except to go at this for days with 80 grit sandpaper
Yub, yub, cmdr! is offline  
Reply Like