RCU Forums - View Single Post - UcanDo3D .46 3D trim question
Thread: UcanDo3D .46 3D trim question
View Single Post
Old 08-31-2004 | 08:40 PM
  #8  
fiveoboy01's Avatar
fiveoboy01
Senior Member
My Feedback: (3)
 
Joined: Mar 2004
Posts: 641
Likes: 0
Received 0 Likes on 0 Posts
From: Waunakee, WI
Default RE: UcanDo3D .46 3D trim question
JC, in my experience, yes the plane needs upthrust.

I am also using the Saito .91.

I ended up putting in a little bit of upthrust, and a LOT of right thrust, using 4-40 washers behind the engine mount, so I wouldn't have to fight it so much in a hover.
fiveoboy01 is offline  
Reply Like