RCU Forums - View Single Post - UcanDo3D .46 3D trim question
Thread: UcanDo3D .46 3D trim question
View Single Post
Old 09-01-2004 | 09:12 PM
  #9  
rc4me2
Senior Member
My Feedback: (13)
 
Joined: Jan 2002
Posts: 194
Likes: 0
Received 0 Likes on 0 Posts
From: Ypsilanti, MI
Default RE: UcanDo3D .46 3D trim question
Bill,

Thanks for your advice, I'll be breaking out the jar of washers tomorrow.

JC
ORIGINAL: fiveoboy01

JC, in my experience, yes the plane needs upthrust.

I am also using the Saito .91.

I ended up putting in a little bit of upthrust, and a LOT of right thrust, using 4-40 washers behind the engine mount, so I wouldn't have to fight it so much in a hover.
rc4me2 is offline  
Reply Like