RCU Forums - View Single Post - ball bearing vs bushing servos
Thread: ball bearing vs bushing servos
View Single Post
Old 09-06-2004 | 04:10 PM
  #7  
Jimmbbo's Avatar
Jimmbbo
Senior Member
 
Joined: Sep 2003
Posts: 1,180
Likes: 0
Received 0 Likes on 0 Posts
From: Fresno, CA
Default RE: ball bearing vs bushing servos
I install BB servos for high load applications where accuracy and repeatability is required (rudder, aileron, elevator) and the bushed units for less used or light load controls - flaps, pneumatic gear valve, throtttle. Best bang for the buck, IMO

Cheers!

Jim
Jimmbbo is offline  
Reply Like