RE: Mid range problems...mvvs 1.60 gasser
Hey Scoub, I'v read your post on drilling'milling out the 1.60 MVVS carb to 8mm and agree that it would help but one thing Reg. in my mind. After doing this will not your throttle butterfly plate be to small to close it off completely??? Have not looked at mine yet because if I did it would go in my mill right then. Ha. Ha. This is a wonderful little engine and would not give it up for anything. I will end up with the 35 cc in a short short!! It was a little tricky to learn how to start it at first but after finding out the combo and getting it very wet----starts like a pro everytime. Thanks for all the help you and Moen give us on these engine. Hooker53