RCU Forums - View Single Post - New CNC cut autogyro trainer kit (video) **Available November 12, 2004**
Thread: New CNC cut autogyro trainer kit (video) **Available November 12, 2004**
View Single Post
Old 10-15-2004 | 05:21 AM
  #5  
JCaste
Senior Member
 
Joined: Apr 2003
Posts: 238
Likes: 0
Received 0 Likes on 0 Posts
From: Barcelona, SPAIN
Default RE: New CNC cut autogyro trainer kit (video)
What I see in its nose is a Norvel? Could you tell me a bit about it, I was thinking of buying one of them too.
Very nice looking gyro, I'm on a similar project to make use of my spare foam.
Good luck with this project!
JCaste is offline  
Reply Like