RCU Forums - View Single Post - U Can Do 3D
Thread: U Can Do 3D
View Single Post
Old 11-17-2002 | 06:35 PM
  #509  
Fred's Avatar
Fred
Member
My Feedback: (21)
 
Joined: Apr 2002
Posts: 91
Likes: 0
Received 0 Likes on 0 Posts
From: Dumas, TX
Default Hi RCad,,

I did read the review..but it was after the fact that I was allready flying mine,,it is a true and to the point review good job !
AS for me getting the flatspin ..I stall the plane which is darn hard to do ,but I get it stopped switch to 3D rates,,add full down flapps then full down ele. full Right rudder full Left aileron and hole it for 2 turns,then start adding power and feed Right Aileron back in real slow the more power you add the flatter it getts and eventually it just stop's falling and does a Sit & Spin,,COOL !,,keep adding power and it will start climbing the climb is slow but it does. I have my CG 6 1/4 back..no broblems with it this far back yet ,,It does a nice wing tip spinn with the CG this far back also ,,I am going to take the MDS 148 off and put my YS 91 on it..and see what happens ,,)
Have A Great Weekend & Burn Lots Nitro ,,