RCU Forums - View Single Post - U Can Do 3D
Thread: U Can Do 3D
View Single Post
Old 12-09-2002 | 05:08 AM
  #597  
searcher
Member
My Feedback: (1)
 
Joined: Aug 2002
Posts: 78
Likes: 0
Received 0 Likes on 0 Posts
From: Northern CAL
Default Saito 1.80 powered UCANDO

There is no such thing as too much power so I installed a Saito 1.80 single cylinder in my UCANDO. Yes, I've added a few ounces to the tail, but the accelleration out of a hover has to be seen to be believed! She actually will hover a few clicks off idle with a 16x8 prop.

She has unlimited vertical. I have literally flown her straight up until I couldnt hear the motor anymore and lost sight of the plane. I cut the motor back to an idle and applied full up elevator and left aileron until I could see her again... it took about 15 seconds :stupid: .

I fly off of a grass runway, so I beefed up the weak landing gear and so far... it has been working great!