RCU Forums - View Single Post - U Can Do 3D
Thread: U Can Do 3D
View Single Post
Old 04-12-2003 | 02:26 PM
  #948  
kram-RCU's Avatar
kram-RCU
Senior Member
 
Joined: Oct 2002
Posts: 557
Likes: 0
Received 0 Likes on 0 Posts
From: ames, IA,
Default Saito questions

I love the Saito upright. Must admit I've never tried it inverted.

I found the APC 15 X 6 prop works best for me. Getting about 9,600 rpm running a little rich, on 15% FS CoolPower at 1,100 ft.

I just followed the standard instructions for engine mounting...no extra washers.

Fuel tank is plenty adequate for 7-10 minutes depending on throttle settings. A lot of aerobatic stuff with this plane/this engine is surprisingly low throttle. I don't know about you, but after 7-10 minutes of practicing stuff I'm not good at, I'm ready for a break.

mt