RCU Forums - View Single Post - 3D Foamy
Thread: 3D Foamy
View Single Post
Old 11-01-2004 | 10:11 PM
  #32  
t1nk's Avatar
t1nk
Member
 
Joined: Sep 2004
Posts: 61
Likes: 0
Received 0 Likes on 0 Posts
From: Milledegville, GA
Default RE: 3D Foamy

Tashley -

I have indeed kept the pen and calculator out, and have everything (i hope) i need. Here is my proposed setup:

- Himax 2015-4100 Brushless w/ GWS gear drive (I chose this cause the motor and geardrive came in package deals)

- GWS 12*6 Prop

- Castle Creations Phoenix 25 AMP

- E-tec 3 cell 1200 MAH Lipo

- (4) Micro 9 servos

* By the way, I'm either getting the CAP 232 or Edge, im still undecided (any suggestions would be appreciated). The price of all this came to a little over 300 bucks, which is what i have found most package deals to be w/ about the same setup. Do ya'll see anything I'm missing or have left out, or maybe need to switch something around? I have my transmitter and "regular" receiver (to keep price down). Once again, holler at ANYTHING you think might be better. Thanks [sm=spinnyeyes.gif]
- Ben