RCU Forums - View Single Post - Chip Hyde's Vision 3D
View Single Post
Old 11-09-2004 | 06:06 AM
  #53  
Daryl g lane
Junior Member
 
Joined: Sep 2003
Posts: 17
Likes: 0
Received 0 Likes on 0 Posts
From: brandon, MS
Default RE: Chip Hyde's Vision 3D

I have three props to try on this plane 22/8,23/8 and this are Mejzlik,the other is a23/8 bolly.I got the tune pipe set-up with my engine from DA and I am very pleased with it,but the plane turned out a little heavey [16.5].the other thing i did was i used carbon rods on all controls incuding rudder.PS the CG is 1/4 behind the wing tube.