RCU Forums - View Single Post - Chip Hyde's Vision 3D

11-09-2004 | 01:01 PM

#54

Maudib

Senior Member

My Feedback: (51)

Joined: Jul 2002

Posts: 5,833

Likes: 0

Received 0 Likes on 0 Posts

From: Ashland, KY

RE: Chip Hyde's Vision 3D

Daryl,

Could you specify your setup?

Servos, batteries, regulators (if any), tank, wheels, etc...

What did you do in order to balance at the 1/4" behind the wingtube?

Quote:

ORIGINAL: Daryl g lane

I have three props to try on this plane 22/8,23/8 and this are Mejzlik,the other is a23/8 bolly.I got the tune pipe set-up with my engine from DA and I am very pleased with it,but the plane turned out a little heavey [16.5].the other thing i did was i used carbon rods on all controls incuding rudder.PS the CG is 1/4 behind the wing tube.

Reply Like