Hey Mike, That would be great! Thanks man. That's funny, i was thinking the same thing Grade A butter! That's funny.

Itneresting enough, I'm putting to gether a Tamyia TLT1 right now and the ball dif in that comes with this wonderful little thrust bearing all set up already in an enclosed little washer set like ting... It's the best I've seen! No worry of them falling out that is for sure! I imagine they will be a ***** to clean though. Or maybe no worse then normal bearings. Seems to me that the thrust bearing is the most critical part of the whole diff and it's also the most neglected in most cases.

I look forward to hearing about the Tc3 diff plates. Thanks, G.