I am re doing the decals on my marder as i was not very keen on the 'flaming skulls' that i had on it. So i went out and found three rolls of coloured vinyl from B&Q. Its Called Fablon. Each roll is 450mm. and i have Red, Blue and Black These are to make my own design. This i have done, and might i say it looks a lot better than FGUK's atempt on his marder i must say. Sorry Aaron.

No my question is, i have lots of tuning images and i want them to be either cut out of the said vinyl or stuck on with normal self adesive label (these being non waterproof)

And bare in mind that the tuning logos have lost of small and delicate parts.

Any advice tips would be very much appreciated thank you

Dazza