I need some help.

I have a mac 28cc engine with a CH ignition on it. I flew it on an ultra stick about a month ago.

During the flight, it died after a couple of minutes and I knocked the gear off on the deadstick. (I didnt make it back to the landing strip due to balance probs. That was addressed in another thread)

Anyway, now it wont start. Got fuel, got spark, battery is charged. I was running a MA 18x8 on it (overpropped, i know) and I havent touched anything since. I even pulled the plug and squirted some fuel into the cylinder. Also tried Hot Shot (I avoid that stuff if at all possible). Not even a pop. My arm is very tired.

Before this, once primed, it would kick on the first or second flip.

I dont know what could have happened. The engine didnt hit the ground and when I pull the plug it seems to have a good spark.

Any suggestions?

In my frustration, I am considering putting my Ryobi 31 on there and just deal with the magneto and starter.

Rob