Originally posted by GPutt33
My wife had gone to visit her folks for a month, ssoooo, I built my workbench out of a nice 4 x 8 sheet of 1" ply I had left over. This was also my launch into RC Planes (my brother talked me into it 
) I do have a question, what has everyone found to be a nice top to layer with to allow you to use push pins, etc. The ply is way to hard as is...... 
This was me in the middle of my first plane, a SIG Kadet LT-40, and it just flys great :sunsmiley I am having SO MUCH FUN!! Should have got into this when my brother started......
Oh Yea - to finish the story.....
I managed to tell my wife about my new hobby in bits and pieces before she got back home :surprised
I told her I had built this really nice work bench in the garage for her :spinnyeye
a furr or mohgony 36/48in hallow core door work's grate . pin's can be pushed all the way thrue the core
just get a good flate one.by siteing down the edge's