Hello,
I recently picked up at a swap meet a u-can-do 3d .46. Plane looks awesome and well built.

My question is about servos. I am thinking of using JR 537 servos in this plane, or maybe the DS537 servos, but in reading the specs on web sites it says it needs 50oz servos everywhere and 90 oz servos on the rudder.

Are the 537 servos enough? Are the DS537's noticably better (even in less demanding planes)?. Or do I need better servos all around?

Finally, well a .46fx run this pretty good. I'm going to order the tower hobbies muffler that seems to get good comments.

Thanks for any assistance!