RCU Forums - View Single Post - Vectorflight Edge 540 build
View Single Post
Old 02-06-2005 | 01:44 PM
  #700  
RBgunner
Senior Member
My Feedback: (8)
 
Joined: Dec 2004
Posts: 134
Likes: 0
Received 0 Likes on 0 Posts
From: Sebastian, FL
Default RE: Vectorflight Edge 540 build

Well, I did not maiden my Edge today. Was all set to, but decided to fly my FuntanaS 40 first to warm up. I was on my second flight and just coming around (about 75 feet off the ground or so) on a regular old turn when she flipped over and dove into the ground.[:@] I have no clue what happened. I may have been shot down, but no one would admit it. After that I was in no mood to fly a new plane. Bad carma all over the place after that. The good thing is the engine (Saito 82) and all the electronic are ok. I did fly my Katana profile a bunch after that without any problems. Oh well, now I need a new plane to put my 82 in. Any suggestions. Ron[8D]