RCU Forums - View Single Post - Carving the Spinner for Props???
Thread: Carving the Spinner for Props???
View Single Post
Old 09-15-2002 | 02:01 PM
  #4  
Dave Barrow-RCU
Senior Member
 
Joined: Dec 2001
Posts: 481
Likes: 0
Received 0 Likes on 0 Posts
From: Covington, KY
Default Carving the Spinner for Props???
You can get a dremel for a lot less than the hospital bill to sew up your hand, as a friend of mine found out the hard way. Get the dremel, you'll find lots of uses for it in this hobby.
Dave Barrow-RCU is offline  
Reply Like