RCU Forums - View Single Post - Carving the Spinner for Props???
Thread: Carving the Spinner for Props???
View Single Post
Old 09-15-2002 | 03:13 PM
  #5  
RussianFlyer's Avatar
RussianFlyer
Senior Member
 
Joined: Dec 2001
Posts: 266
Likes: 0
Received 0 Likes on 0 Posts
From: Houston, TX
Default Carving the Spinner for Props???
Thanks for the suggestions,

I will try to use a file to enlarge the opennings and if all else fails will probably get myself a Dremel tool. Gotta get it sooner or later.

Thanks again for the help!

RF
RussianFlyer is offline  
Reply Like