RCU Forums - View Single Post - Will this work?
Thread: Will this work?
View Single Post
Old 09-19-2002 | 07:02 AM
  #3  
Giant Scale
Senior Member
 
Joined: Jun 2002
Posts: 856
Likes: 0
Received 0 Likes on 0 Posts
From: Baltimore, MD
Default Will this work?
Juice,
Why not just eliminate the pulley and use a pushrod from the servo. Can't see any advantage to using a pulley, just seems like something else that could break. Also unsure how the surface would move in relation to the servo.
Giant Scale is offline  
Reply Like