RCU Forums - View Single Post - Futaba 9C programing?
Thread: Futaba 9C programing?
View Single Post
Old 03-15-2005 | 10:41 PM
  #3  
1Eye's Avatar
1Eye
Senior Member
My Feedback: (2)
 
Joined: Dec 2001
Posts: 1,106
Received 0 Likes on 0 Posts
From: Mesquite, Nevada
Default RE: Futaba 9C programing?
tcblr wrote ...
I'm trying to configure my flaps on one of the three position switches
Yup I needed help on that too but when dialed it it works perfect - I'm hoping my resident expert will roll in (here) with the specific steps, be patient ...

Mike
1Eye is offline  
Reply Like