RCU Forums - View Single Post - First build - Sig SE started
Thread: First build - Sig SE started
View Single Post
Old 03-16-2005 | 10:29 AM
  #48  
tychoc's Avatar
tychoc
 
Joined: Mar 2004
Posts: 725
Likes: 0
Received 0 Likes on 0 Posts
From: Cedar Park, TX
Default RE: First build - Sig SE started
I tried with a regular Futaba S3004 servo. Without bending the wire, it ends up underneath...
I was surprise though, not reading about this in all the other threds about the SE I scanned before starting the build.

-tycho
tychoc is offline  
Reply Like