That's what I thought, I had forgotten about the order!! Thanks!

Now heres another weird event that happened yesterday night. I installed a aileron servo on the wing of my Spad Debut and when I started testing the aileron movement my servo would move, not jitter but really move fast from one side to the other by itself... and then center itself and stop after 1-2 seconds. Of course, I freaked out and was almost sure my servo had damage done to it or something... and I didn't want to go out and buy another radio or wait a couple of weeks for a servo from JR to by shipped to me or something.

So I took the servo out and placed another one and it worked fine, so I know that the problem is the servo and not the transmitter or receiver.

Before going to bed I decided to take another look at the servo, this is what I did to it. I took a hammer and smashed it... ok I'm just kidding of course.. While the tx and rx were off, I moved the servo motor by hand all the way clockwise. Turn everything on, could not move anything, looked like the servo was now really broken. Being the type of person who doesn't give up easily, I turned the rx and tx off and move counterclockwise... Turn everything on and now I could move and the servo is working perfectly fine (No turning around a few times and centering itself)

Now, can someone explain to me what happened?