Hi guys I have a dubro prop balencer that I just baufht and am going nuts. I think I just buchered one prop to deth trying to balence it and now I think I need to toss it. This is when the prop is on the balencer and mov it to say 10 to 4 o'clock the 10 0'clock side will start to fall. Ok so that means that is the heavy side and I need to sand a little of the back or add some weight to the light side but if I rotate the prop to say 2 o'clock (mind you I have not done anything to the side that just registered heavy) to 7 o'clock now it is showing that the side that was light is now heavy. So THe prop I buthered is because I have been doing this constently and can't find a balence. should it be this hard? It just seems wrong and I am pissed that I butchered my new prop.


Please, please help

Thanks,
Rob