RCU Forums - View Single Post - Using a bushing engine for a pusher?
Thread: Using a bushing engine for a pusher?
View Single Post
Old 05-25-2005 | 03:55 PM
  #6  
Sport Flyer's Avatar
Sport Flyer
Senior Member
My Feedback: (10)
 
Joined: Dec 2001
Posts: 406
Likes: 0
Received 0 Likes on 0 Posts
From: Portage La Prairie, MB, CANADA
Default RE: Using a bushing engine for a pusher?
I first used a Magnum GP15 on the tail end of my Sig Tri Star. The results weren't good. After two flights there was very noticible wear, with the drive hub pushing into and wearing the engine case. I switched engines to an MDS 18 and have not experienced any problems because of the configuration. Problems because of the MDS, yes .... but its much better now. [8D]
Sport Flyer is offline  
Reply Like