RCU Forums - View Single Post - Using a bushing engine for a pusher?
Thread: Using a bushing engine for a pusher?
View Single Post
Old 05-25-2005 | 05:37 PM
  #9  
Hobbsy's Avatar
Hobbsy
My Feedback: (102)
 
Joined: Dec 2001
Posts: 20,370
Likes: 0
Received 30 Likes on 28 Posts
From: Colonial Beach, VA
Default RE: Using a bushing engine for a pusher?
I measured both my LA .46 and .65 and could not get a .008 feeler guage between the crankshaft shoulder and the washer when the washer was against the prop driver. A Saito feeler guage would just slide in there with no wiggling room.
Hobbsy is offline  
Reply Like