RCU Forums - View Single Post - Vectorflight Edge 540 build
View Single Post
Old 06-02-2005 | 08:21 PM
  #1034  
Sturtz's Avatar
Sturtz
My Feedback: (20)
 
Joined: Sep 2004
Posts: 1,537
Likes: 0
Received 0 Likes on 0 Posts
From: El Reno, OK
Default RE: Vectorflight Edge 540 build

That strip looks really short though!
Naw,,, it's not the strip. Over 250-foot long by 28 feet wide with a 75 square foot apron. It was my fault. There are very few days here when the wind is at absolute zero and I was aiming my finals like normal. Over shot the landing point everytime yesterday.
Plus I was taking off from the middle of the runway like I always do with some wind.
Just not use to flying without at least a little wind. Guess I could have used my air brakes (programmed into ailerons). But I will try and get more video. I have a vid of my CMP Spitfire taken yesterday too if you wanna see it. I overshoot the final with it as well.

what engine/prop combo are you using again?

It's a Saito 100 with a 15x6 APC.