RCU Forums - View Single Post - Hitec 5745 problem
Thread: Hitec 5745 problem
View Single Post
Old 06-05-2005 | 01:48 PM
  #7  
madgti
Senior Member
 
Joined: Mar 2005
Posts: 503
Likes: 0
Received 0 Likes on 0 Posts
From: , ON, CANADA
Default RE: Hitec 5745 problem
Hey no problem.

No i don't know anyone with a programmer.

MY STC is set to 0
my EPA is set to 90 on both directions

With this setting i get full range in movement in both directions. BUt once i install it in the truck ofcourse i need to trim the servo since the servo arm is not sitting dead center and when it is trimmed i loose range on one of the directions.

Don't these servos come from the factory calibrated to be dead on?
madgti is offline  
Reply Like