RCU Forums - View Single Post - Anyone running an SH .28 in a conversion Maxx?
Thread: Anyone running an SH .28 in a conversion Maxx?
View Single Post
Old 06-09-2005 | 02:33 AM
  #1  
PhaedruS's Avatar
PhaedruS
Senior Member
My Feedback: (1)
 
Joined: Jan 2004
Posts: 104
Likes: 0
Received 0 Likes on 0 Posts
From: Escondido, CA
Default Anyone running an SH .28 in a conversion Maxx?
I have an XTM .21 converted Maxx with a 24.7 on it. The 247 had a threaded shaft that was cut to acccept a clutch nut with a long shaft. The SH only comes with an SG shaft. What is a workable setup here? The LHS guy said I might try the XLB clutch nut setup.

What do you run?
PhaedruS is offline  
Reply Like