RCU Forums - View Single Post - modeltech twister
View Single Post
Old 06-16-2005 | 10:26 AM
  #31  
jody-RCU
Member
 
Joined: Dec 2002
Posts: 35
Likes: 0
Received 0 Likes on 0 Posts
From: beulaville, NC
Default RE: modeltech twister

Well i went to the field this morning and got a couple fights in. The wind was about 8-10mph. It tracked wery well snap rolls very tight knife edge was great. didnt get to try ant thing fancy with it to windy. From what i could tell it flys very well I didnt have to add any trim at all and the controlls are very responsive on low rates.(i dont even have the hinge lines sealed) I think this plane is going to be a lot of fun?