I am looking into getting into electrics, been into 3d flying with gas for years now.

which would be better, a flatout of the tensor 4d, or should I just get some plans and make my own to begin with, I am able to get depron foam out here from anywhere from 1 to 6 mm.

As for engines, I am looking at an outrunner by e-flite, mpi or hi-maxx, or go with a rimfire? From what others are saying on other posts, I would probably go with a e-flite 20 amp speed controller.

as for batteries, maybe a kokam 3 cell or 2 cell 700 mah li-po, or e-tec 3s1p 700 mah, is the greatplanes batteries any good?

thanks