RCU Forums - View Single Post - Control horn installations..
Thread: Control horn installations..
View Single Post
Old 12-17-2002 | 07:34 PM
  #25  
Dzlstunter
 
Joined: Dec 2001
Posts: 488
Likes: 0
Received 0 Likes on 0 Posts
From: Jacksonville, IL
Default Control horn installations..
I don't understand how any of the alignment methods so far (except the single hole method or the circuit board method) would help much with tapered control surfaces. The alignment of 4 holes thru a tapered section has always been one of my least favorite building tasks. Dzl
Dzlstunter is offline  
Reply Like