RCU Forums - View Single Post - question on angle of force modification
Thread: question on angle of force modification
View Single Post
Old 07-16-2005 | 12:31 PM
  #6  
onewasp
Senior Member
 
Joined: Dec 2002
Posts: 2,035
Likes: 0
Received 0 Likes on 0 Posts
From: USA
Default RE: question on angle of force modification
'Normal' set up for conventional gear would place the wheel center @ approximately the leading edge. Your drawings indicate a location behind that----TallPaul is quite right.
onewasp is offline  
Reply Like