RCU Forums - View Single Post - For the engine builders: a simple prop driver?
Thread: For the engine builders: a simple prop driver?
View Single Post
Old 07-31-2005 | 11:30 PM
  #5  
combatpigg's Avatar
combatpigg
Senior Member
My Feedback: (3)
 
Joined: Nov 2003
Posts: 20,448
Received 44 Likes on 40 Posts
From: arlington, WA
Default RE: For the engine builders: a simple prop driver?
Not only is it a breaking point, but it also cocks the rest of the threaded part of the shaft minutely when you tighten the prop washer. I still think this arrangement will work for low powered 1/2A and below.
combatpigg is offline  
Reply Like