Thanks for all the feedback! Tower Hobbies took the frist bite outta my Visa today(LT-40 and some tools/parts). After a few trips to the LHS in the next few days I should be able to start building next week.

I have a heat gun already for the covering.

Ordered the hardware for the taildragger setup.

Gonna go with the CA hinges to begin with though common sense makes me wonder about flexing a piece of plastic so much... but I'll trust Sig.

I was going to go with the aluminum spinner with what I'd read in another thread regarding plastic spinners busting apart or whatnot plus it'd look cool.

I need to pickup a strip of fiberglass for the wing half joint.

I found 5 minute and 60 minute epoxy... should I just use the 60 minute for what I need to epoxy?

Gotta figure out a color scheme...

Will start up a thread when I start my build and take pics to share.

This message board is a great resource!

somegeek