I don't know-I'll have a look at it. What am I adjusting to get them horizontal?

It was a reinforced cup-I did the long strip of aluminum foil with CA glue around the outside of the diff cup. All that was left of the cup was the part that goes into the diff. Had to use a needle nosed pliers to pull that out. A 2mm length of fuel hose where? between the end of the dogbone, and the inside of the diff cup?

It was the screw that goes through the strut, then the pillowball, and into the lower wishbone.

I've been having a blast with it. I need to get one of my mates to come out there with me and film it, while I am running the truck. My 3 year old son has been coming out with me, and he's great about carrying around a couple of tools, and the squeeze bottle of fuel for me, but asking him to run a camera is a bit much right now

The truck is officially down until the new tie rod end gets here from E-Hobbies. I ordered several, so I won't be down, due to this particular part failing, again. Once I get the parts in (should be mid-week) I'll try to get back out there with a cameraman.

Ken