RCU Forums - View Single Post - Building a DraganFlyer - need to mix speedcontrollers - HELP
Thread: Building a DraganFlyer - need to mix speedcontrollers - HELP
View Single Post
Old 08-14-2005 | 03:28 AM
  #2090  
ADI's Avatar
ADI
Senior Member
 
Joined: Mar 2004
Posts: 820
Likes: 0
Received 0 Likes on 0 Posts
From: Christchurch, NEW ZEALAND
Default RE: Building a DraganFlyer - need to mix speedcontrollers - HELP
ORIGINAL: kwaiweng
Will it make much different after changing the diode? cause the shipping to my country is not cheap. How long is your flight time? mine one is just a few minutes only, i think is less than 10 minutes and it's not continuous.
It may not make much change, but 1N5819 just seemed a bit low, current wise.
I'm using 4400 mah lipol so will have more flying time than 10 minutes.
I haven't tested total battery flying time yet. Have you checked out the shipping cost at http://www.sicom.co.nz ?

ADI
ADI is offline  
Reply Like