Checked the airframe today, fuselage and wings seem ok. The ailerons have some warp, I will try with the iron to make them straight. It is not only a matter of covering but construction. If they don't get straight with heat, I will tear the covering beneath and try to reconstruct them where needed.

YS-110 is on its way. Now I'm on the servo selection I think of Dig JR-8425 (same with 8411) on elavator and rudder and HiTec 5945 or 5925 on ailerons. Any opinions?

Is a 14oz tank enough for the 110? I think of getting a special YS high pressure tank by MK or Tetra.