RCU Forums - View Single Post - Showtime engine and servos?
Thread: Showtime engine and servos?
View Single Post
Old 08-18-2005 | 04:53 PM
  #6  
OAK
 
Joined: Jun 2003
Posts: 56
Likes: 0
Received 1 Like on 1 Post
From: Lier, NORWAY
Default RE: Showtime engine and servos?
Do you guys that recommend metal-geared servos have any thoughts about if this is really required on all control-surfaces? Until now I have only seen reports of ailerons fluttering. I am personally using Futaba S9252 on the elevators (nylon-geared), and they have been fine so far. "Knock on wood"! Metal-geared on the rest though.

Regards
OAK
OAK is offline  
Reply Like