RCU Forums - View Single Post - Sig LT-40 Build (maiden a success!!)
Thread: Sig LT-40 Build (maiden a success!!)
View Single Post
Old 08-26-2005 | 10:19 AM
  #85  
cwrr5's Avatar
cwrr5
My Feedback: (32)
 
Joined: May 2004
Posts: 2,150
Likes: 0
Received 0 Likes on 0 Posts
From: Marana, AZ
Default RE: Sig LT-40 Build

ORIGINAL: somegeek

One item that I wanted to get an answer on and haven't gotten a reply is the pre-cut dihedral guage:

The dihedreal guage side is cut with a curve which messed up the angle of the W1 rib where the shorter end of the rib was less angled than the taller part of the rib so the W1 ribs were not totally flush against each other when joined. I am thinking this guage shoud be completely flat on that edge. Any input from the board elders?
I agree, that side should be flat, at the correct angle to set the dihedral. (I'll have to check mine when I get home).

"board elders"?!?!?

Does that mean Bruce and Ken? LOL!
cwrr5 is offline  
Reply Like