RCU Forums - View Single Post - Who is converting Toro trimmers?
Thread: Who is converting Toro trimmers?
View Single Post
Old 09-03-2005 | 11:06 PM
  #73  
davewallace
Senior Member
My Feedback: (29)
 
Joined: Jan 2005
Posts: 1,402
Likes: 0
Received 0 Likes on 0 Posts
From: San Antonio, TX
Default RE: Who is converting Toro trimmers?
Hi Scott,
Since I got your attention, I thought that I'd ask you a question. On the McCulloch 38cc's that you converted did you do anything special for the thrust bearing? My Mac's shaft will have to ride on the end of the roller bearing cage. Is this what you did with yours?

Dave
davewallace is offline  
Reply Like