RCU Forums - View Single Post - POLL: Engine for UCD3D?
View Single Post
Old 10-28-2002 | 07:47 PM
  #9  
cmassa's Avatar
cmassa
Senior Member
 
Joined: Jan 2002
Posts: 162
Likes: 0
Received 1 Like on 1 Post
From: Chico, CA
Default POLL: Engine for UCD3D?

The wing is removeable. Two bolts hold it on. The stab is removeable too if needed. This is not a small plane though. The fuselage is 68 in. the wing is 64 in. The fin stands up about 15-16 inches (haven't measured it). So it needs some room for transporting. I'm flying mine with a YS91FZ which is plenty of power for me. Pulls vertical out of hover without difficulty. I put the tank over the CG (need to trim out one former) and the throttle servo and battery in the rear of the wing opening. Balances at 5 1/4 inches without any weight on the tail. Great flying plane.

Chris