I'll be going out later this afternoon for the maiden. My stupid birthday lunch with the family is preventing me from going out earlier [:@]

The control arms are the stock carbon fiber rods and ends. I just used JB Weld to secure the ends and then put some shrink tubing around it to squeeze and hold the JB in place. I wish I could remember if it was Great Planes or Hangar 9 (I think it is the latter) who make the HD control horns.

The tail wheel should hold up just fine. I can let the tail drop from way up high and it doesn't crack the cf at all when it hits the ground.

I'll get back to you fella's on the maiden later tonight!

Cheers,

John