RE: Aeroworks 33% Edge ARF
Thanks for the info.
I just bought one ready to fly. I bought it for the DA 100 however I find myself considering keeping the whole plane.
The last few months I have been flying the Hangar 9 Edge with a DA 100 and needed some info on how the heavier larger Aeroworks Edge would compare.
I would fly it but it would take too much effort just for a couple of flights if it didnt warrant keeping it, ie. I would have to swap out the two JR RX for a couple of negative shift RX and then program in all the surfaces.
The plane itself is really nice, only about 60 flights, the wheel pants dont even have a scratch.
It has eight 8411s all around, Hays smoke pump, two tanks, CF landing gear, 2 JR RX, Nelson horns, Three heavy duty switches and a nice pilot figure.
So what I gather even at 27lbs it will 3D OK. Tough decision to keep it or part it out!
Thanks Gary