RCU Forums - View Single Post - Radio Setup for dual elevator servos
Thread: Radio Setup for dual elevator servos
View Single Post
Old 10-02-2005 | 08:05 PM
  #4  
CGAV8R's Avatar
CGAV8R
Senior Member
My Feedback: (2)
 
Joined: Dec 2002
Posts: 429
Likes: 0
Received 0 Likes on 0 Posts
From: Hudson, FL
Default RE: Radio Setup for dual elevator servos
The problem I ran into when I did the mix with another channel is only one elevator half would move when I used the trim.
Make sure both halves move when you trim it.
Aaron
CGAV8R is offline  
Reply Like